Care And Maintenance; Troubleshooting - Crunch BLACK Series Operation Manual

VG-2 Alerts
The VG-2, also known as a "radar detector detector", is a special receiver used
by police to detect signals radiated by a radar detector.
When a VG-2 signal is detected, the alert is sounded and both „X‟ and „K/Ka‟
band indicators will flash.
VG-2 Select Operation
Pressing both DIM and CITY buttons for three seconds, your CRUNCH will
disengage VG-2 feature with two beeps sound.
Pressing both DIM and CITY buttons again, your CRUNCH will engage VG-2
feature with one beep sound. Factory default is „VG-2 On‟.
Pulse Protection
Pulse (or instant-on) radar is more difficult to detect than conventional radar
because it remains "off" until activated to measure the speed of a targeted
vehicle.
When a pulse type transmission is detected, your CRUNCH detector sounds an
urgent audio warning and flashes the Alert strength indicators at their fastest
rate.

CARE AND MAINTENANCE

Your CRUNCH is an example of superior design and craftsmanship.
The following suggestions will help you to handle your detector in a proper way
so you can enjoy it for years.
Never leave the detector on the windshield or dashboard when you park
vehicle. The temperature in the vehicle in summer can reach levels above
your
what is considered to be safe for this detector.
To make you less susceptible to break-in and theft, remove the detector from
your windshield or dashboard when you leave your vehicle.
Do not expose the detector to moisture. Rain dew, road splash, or other liquids
can damage the internal components and reduce sensitivity of the detector.

TROUBLESHOOTING

If the detector does not turn on:
1. Check the power cord. Be sure all power connectors are properly
installed.
22
Интернет-магазин автотоваров «130»