Crunch BLACK Series Operation Manual page 20

Follow these instructions to use the hook-and-loop
tape.
1. Use a damp cloth to thoroughly clean both the
bottom of the detector and the dashboard.
2. Peel off the tape's paper backing and apply the
tape to the bottom of the detector.
3. Remove the paper backing from the other side
of the tape and press the detector onto the
dashboard.
Windshield Mounting
The supplied windshield bracket and suction cups let
you quickly mount the detector to your vehicle's
windshield.
Follow these steps to use mounting bracket kit.
1. Install the suction cups onto the bracket by fitting them into their holes.
2. Attach the bracket to windshield.
3. Attach Detector to bracket.
4. Bend bracket for correct detection angle (if necessary), do not use the
CRUNCH 214B to bend bracket.
5. Plug power cord DC12V into detector.
6. Plug power cord into cigarette lighter.
Cautions: Some new models of cars have a plastic safety coating which is
applied to the windshield. The suction cups may leave permanent marks on the
windshield once they are removed. Check vehicle owner's manual to see if your
car has the plastic safety coating.
Connecting the Power
The detector is designed to operate on most DC12V negative ground vehicle
electrical systems. The power cord provided with the detector has a cigarette
lighter socket plug at one end and a small connector at the other.
1. Insert the small connector into the jack on the side of the detector.
2. Insert the other end into the cigarette lighter socket of your vehicle.
If the detector does not operate when you turn it on, remove the adapter from
the cigarette lighter socket and carefully check the socket for debris. Also,
check the fuse in the adapter and your vehicle's fuse box.
19
Интернет-магазин автотоваров «130»