Table of Contents
Advertisement
RETAINER SPRING
PIN
AD JUST ING
BAR
SHOULDER
BOLT
GAUGE
WHEEL
3/8 WASHER
TO ATTACH NOSE ROLLER (See Fig. 6)
•
Assemble brackets "A" and "B" to the inside of mower
mounting brack ets as shown. Tighten securely.
NOTE: Be sure bracket tabs are po si tioned in tab holes
in mower brackets.
•
Position nose roller between brackets and install rod
and retainer spring.
LOCKING BRACKET
BELT TENSION ROD
DISENGAGED
POSITION
GAUGE
WHEEL
ASSEMBLY
3/8-16 CENTER
LOCKNUT
FIG. 4
SET ALL WHEELS
TO 4TH HOLE
FROM TOP
FIG. 5
SUSPENSION ARMS
REAR MOWER PINS
TAB
HOLE
"A" BRACKET
RETAINER SPRING
INSTALL MOWER AND DRIVE BELT
(Sees Fig. 7 and 8)
See MOWER AND DRIVE BELT ASSEMBLY Supplement
Sheet for additional guidance on this assembly.
Be sure tractor is on level surface and mower suspension
arms are raised with attachment lift control. Engage park-
ing brake.
•
Turn steering wheel to the left as far as it will go and
position mower on right side of tractor with defl ector
shield to the right.
•
Remove plastic tie strap from mower belt and check
belt for proper routing in all mower pulley grooves.
•
Slide mower under tractor until it is centered under trac-
tor. DO NOT connect any pins. When properly centered
the front mower brackets should be aligned so when
the front suspension plate is lowered it should slide
between the mower brackets.
•
Lower attachment lift lever to lowest position.
•
Cut plastic tie and lower front suspension plate.
ELECTRIC CLUTCH PULLEY
FRONT PLATE ASSEMBLY
FRONT MOWER
BRACKET
FIG. 7
8
HEX BOLT
LOCK
NUT
ROD
"B"
BRACKET
NOSE
ROLLER
FIG. 6
DOUBLE LOOP
RETAINER SPRINGS
FLANGED PIN -
POSITION NOTCH
HORIZONTALLY
DE FLEC TOR SHIELD
Advertisement
Table of Contents
