Authorized warranty replacement parts need to come directly from the manufacturer. Any use of any other parts will void warranty. The manufacturer and Jon-Don, Inc. do not reimburse for parts used by the client that were not supplied directly for the machine under warranty.
The warranty starts on the purchase date by the original purchaser from an authorized Jon-Don, Inc. distributor, subject to proof of purchase. The Machine Registration Form must be completed and sent to the original manufacturer at the time of purchase.
Clean or replace hose and/or filter and repeat the priming process. If you are having trouble with the pump, refer to the “Trouble Shooting Guide” section or contact the Jon-Don technical support team for advice or assistance.
If moisture does enter the vacuum motors, contact your local Jon-Don service center. To prevent moisture from damaging the vacuum motors during storage, empty the recovery tank and store with the lid open.
5.0 Maintenance Regular maintenance is required to keep your Prospector Carpet Extractor in proper working condition. Failure to properly maintain your machine could void warranty. Thoroughly clean all equipment and accessories after each use: • Rinse the solution and recover tanks with clean water. •...
Clean Pump Inlet Filter CAUTION: before proceeding with this procedure, make sure both the power cords are disconnected. • To examine the filter, open the solution tank lid on the front of the machine. The filter is in the bottom of the solution tank.
6.0 Storage and Freeze Protection Continued • Disconnect the solution hose from the chemical feed and allow the system to bypass for 10 minutes. This will work antifreeze into the pressure gauge. • Attach and wands and hand tools that will also be stored with the Prospector Carpet Extractor. Open the valve for 30 seconds, directing the spray to the solution tank.
9.0 Machine Parts List Drawing No. Item ID Item Description Qty. SN-12-ST-BLUGRAN 12-Gallon Solution Tank - Blue Granite 1.00 10-0479 1/4" Male Close Nipple 1.00 10-0845 1/4" Strainer for Extractor 1.00 SN-12-L-BLUGRAN 12-Gallon Lid - Blue Granite 1.00 80-0001 Extractor Exhaust Hose 0.30 80-0040-C 46”...
Page 11
9.0 Machine Parts List Continued Drawing No. Item ID Item Description Qty. 10-0852 1/4" 90 Degree Brass Elbow - Part of 80-0044-L 10-1500-A Heater Element 1000 Watt 2.00 10-0814 Sensor for Extractor Heater 2.00 10-0814-B Manual Sensor for Heater 2.00 10-0921 Aluminum Box for Dual Rod Heater 2.00...