Table of Contents
Advertisement
Faults and what to do about them.
en
Information about the indicator lights
Display*
Cause/Remedy
Close the washing machine door
properly; washing may be
trapped.
Drain pump blocked; clean the
drain pump ~ Page 21
Drain hose/outlet pipe blocked;
clean drain hose on the siphon
~ Page 22
Turn on the tap fully, supply hose
kinked/jammed: Clean the filter
~ Page 22, water pressure too
low.
Faults and what to do about them.
Faults
Water is leaking from the
appliance.
The appliance is not filling
with water.
Detergent is not being dis-
pensed.
The door cannot be
opened.
The programme does not
start.
The water is not draining.
Water is not visible in the
drum.
24
Cause/Remedy
Attach the drain hose correctly or replace it.
■
Tighten the screw joint on the supply hose.
■
Start/Pause not selected?
■
Is the tap turned on?
■
Could the filter be clogged? Clean the filter.
■
Is the supply hose kinked or trapped?
■
The safety function is activated. Wait for approx. 2 minutes.
■
$ (without final spin) selected?
■
Can be opened by emergency release only?
■
Start/Pause selected?
■
Is the door closed?
■
$ (without final spin) selected?
■
Clean the drain pump.
■
Clean the outlet pipe and/or the drain hose.
■
Not a fault – the water is below the visible area.
Display*
Cause/Remedy
Motor fault. Call the after-sales
service.
There is water in the base
trough*, the appliance is leaking.
Call the after-sales service.
* Depending on the model
Advertisement
Table of Contents
