Start The Programme; Adding Laundry; Changing The Programme; Cancel The Programme - Bosch WAE16166IL Series Instruction Manual And Installation Instructions

Measuring aid* for liquid detergent
*Depending on the model
Position the measuring aid for
measuring the correct amount of liquid
detergent:
Pull out the detergent drawer. Press
1.
down the insert and fully remove the
drawer.
Slide the measuring aid forwards,
2.
fold it down and click it into place.
Reinsert the drawer.
3.
Do not use the measuring aid for
Note:
gel detergents and washing powder, or
for programmes with prewash or when
the "Finished in" time is selected.
For models without a measuring aid,
pour the liquid detergent into the
appropriate dispenser and place it in
the drum.

Start the programme

Select the Start/Pause button. The
indicator light lights up and the
programme starts.

Adding laundry

After starting the programme, you can
add or remove laundry as required.
To do this, press the Start/Pause
button.
Do not leave the washing
Note:
machine door open for too long when
adding laundry as water from the
laundry may leak out.
Operating the appliance
For safety reasons, the washing
machine door remains locked when the
water level or temperature is high, or
while the drum is rotating, and it is not
possible to add laundry.
To continue the programme, press the
Start/Pause button. The programme
continues automatically.

Changing the programme

If you have started the wrong
programme by mistake, you can
change the programme as follows:
Select another programme.
1.
Select Start/Pause. The new
2.
programme starts from the
beginning.

Cancel the programme

For programmes at high temperature:
To cool the laundry, select Rinse/
1.
Spin.
Select Start/Pause.
2.
For programmes at low temperatures:
Select Start/Pause.
1.
Select Rinse/Spin (deactivate the
2.
Rinse plus/Aqua plus button) or
select Empty.
Select Start/Pause.
3.
Programme end during rinse
hold
The Rinse Stop and O Rinse indicator
lights light up and the indicator lamp for
the Start/Pause button flashes.
To end the programme, set the
programme selector to "Empty" or
select a spin speed. Then select the
Start/Pause button.
en
17