Emc And Electrical Standard Requirement; Notice To Users And/Or Patients - Weightworld CIRCULATOR User Manual

Problem Possible Cause
The electrode patches
The electrode patches
will undergo wear and
do not stick properly
tear with regular use.
to the skin.
Weak sensation, even Electrode patches
have been over-used,
on high setting.
or are dry.
Sensation is too strong
Setting is too high
Sensation is too weak Sensation is too low
No sensation Incorrect connection
Document No.: CWL-URM-04A
17
Solution
To improve their longevity, please
ensure that the skin on which they are
applied is dry, clean and free of lotions.
Put a few drops of water on the sticky
side of the pad and rub it on the
surface. This should improve its
stickiness.
Also ensure that the electrode patches
are stuck on the protective plastic after
use.
If the electrode patches still do not stick
then contact the authorized dealer to
get them replaced.
Replace electrode patches
Press the button to decrease the setting
Press the button to increase the setting
1.
Make sure that wires are connected
and are not damaged
2.
Verify that the device is turned on
3.
Make sure both electrode patches
are attached to the body
| Revision No.: 00. | Revision Date: 20.06.2022

14. EMC and Electrical standard requirement

Precautions with respect to electromagnetic compatibility are taken.
The Circulator must be installed and prepared to use as described in this manual.
Do not use accessories other than specified or sold by the manufacturer. Use of
replacement parts may lead to increased emission or decrease the immunity of the unit.

15. Notice to Users and/or Patients:

Any serious incident that has occurred in relation to the device, should be REPORTED to
the Manufacturer & the Competent Authority.
Document No.: CWL-URM-04A | Revision No.: 00. | Revision Date: 20.06.2022
18