The two modules sharing a bank must be identical .
2
3
Different banks can contain memory module pairs of different sizes.
4
Install only 4 or 16 MB memory modules in bank C.
UPGRADING TO 2 MB OF VIDEO MEMORY
The upgrade kit comprises two modules of 512 KB. These two modules are identical and must
be installed together, in the position shown under "Replacing the System Board" in this
chapter. When inserting the modules, carefully align the corner dot on the module with the
corner marker on the socket. If a module is incorrectly inserted, you will need the PLLC
Extraction Tool (part number 5041-2553) to remove the module from the socket.
INSTALLING OR REPLACING MASS-STORAGE DRIVES
The integrated IDE hard disk controller has two channels (primary, HDD-recommended, with
two grey connectors, and secondary, CD-ROM-recommended, with one red connector).
INSTALLING THE D3979A COAX ADAPTER
The Ethernet 10 BaseT network board is installed underneath the internal, hard disk drive,
rear-shelf. It is plugged into the PCI accessory slot that is situated on the right-hand side of the
double-sided backplane board.
To use a BNC coax connection, instead of the RJ-45 connection, a coax adapter (D3979A) is
required. Its installation is described in the HP Vectra Accessory Service Handbook (5963-
8034).