Replacing The Floppy Drive - HP Vectra XE310 Upgrade Manual

Replacing the Floppy Drive

WARNING
For your safety, disconnect the power cord and all external cables.
1 Switch off the PC, disconnect the power cord and remove the PC's side panel and air flow guide (refer
to "Removing and Replacing the Side Panel & Air Flow Guide" on page 12).
2 Press the tab on the hard disk drive/floppy disk drive tray and pull the tray out part of the way.
3 Disconnect all cables at the back of the floppy disk drive and hard disk drive.
4 Remove the drive tray from the PC.
5 Remove the two floppy drive fixing screws (one on either side of the drive tray), noting carefully the
position of these screws.
6 Slide the floppy drive out through the front of the tray.
Press here
Upgrading and Replacing PC Hardware
17