Fueling; Fitting The Harness - Stihl FS 120 Instruction Manual

Fueling

: Before fueling, clean the filler cap
and the area around it to ensure that
no dirt falls into the tank.
: Position the unit so that the filler cap
is pointing up.
Take care not to spill fuel while fueling
and do not overfill the tank. STIHL
recommends use of the STIHL filling
system (special accessory).
After fueling, tighten down filler cap
by hand as securely as possible
FS 120, FS 120 R, FS 200, FS 200 R, FS 250, FS 250 R
Changing the Fuel Pickup Body
: Change the fuel pickup body once
every year.
: Drain the fuel tank.
: Use a hook to pull the fuel pickup
body out of the tank and take it off
the hose.
: Push the new pickup body into the
hose.
: Place the pickup body in the tank.
English / AUS

Fitting the Harness

The type and style of harness depend on
the market.
Shoulder Strap
: Put on the shoulder strap (1).
: Adjust the length of the strap so that
the spring hook (2) is about a hand's
width below your right hip.
: Balance the brushcutter.
The use of the harness is described in
chapter "Approved Combinations of
Cutting Tool, Deflector, Handle and
Harness".
27