To Stop The Product; To Adjust The Wheels Of The Product; Maintenance; Troubleshooting - Kayoba 012288 Operating Instructions Manual

● To stop the product, release the speed control trigger.

4.4 To stop the product

● Release the speed control trigger to stop the product.
Caution! Release the speed control trigger if a
collision occurs.
4.5 To adjust the wheels of the
product
Note! If the product does not move straight forward when
the control wheel is in neutral position, wheels must be
adjusted.
1
Turn the wheel adjustment knob counterclockwise
fully. (Figure 9)
2
Turn the wheel adjustment knob clockwise until the
wheels point forward.
3
Start the product. Refer to "4.2 To start the product"
on page 22.
4
Make sure that the control wheel is in neutral
position.
6

Troubleshooting

Problem
The product does not start.
The product does not drive forward.
The product stops.
2022_001
5
5
● Make sure that nuts and screws are tightened.
● Lubricate all moving parts with suitable oil.
● Clean the product regularly.
● Remove the battery from the product when you store the
product.
● Remove the battery from the remote control when you
store the remote control.
Cause
Faulty start procedure.
Defective/incorrect battery type or
placement.
The product is not fully charged.
High buildings and walls can interfere
with the radio signal.
Magnetic fields around high voltage
cables or signals from other
transmitters can interfere with the radio
signal.
The batteries are defective.
The battery in the product is not fully
charged.
If the product does not move straight forward, turn
the wheel adjustment knob until the product drive
straight forward.

Maintenance

Warning! Only use the supplied charger.
Make sure to first start the product and
the remote control after. Refer to "4.2 To
start the product" on page 22.
If the green LED indicator on the
remote control does not go on. Make
sure that the batteries are correctly
inserted and in good condition.
Refer to "4.1 To charge the product" on
page 22.
Move the product to another location.
Move the product to another location.
Replace the batteries. Refer to "3.1 To
assemble the remote control" on
page 22.
Refer to"4.1 To charge the product" on
page 22.
Action
23