GMC Chevrolet Express 2022 Owner's Manual page 26

8. For the second and third row seats, stow
the seat belt latch by attaching the clip
on the seat belt latch to the trim just
inside the side door.
For the last row of seats, stow the seat
belt latch plate on the clip at the
window trim. Roll the mini-latch into the
seat belt webbing and then hook the
seat belt latch plate on the clip.
Reinstalling the Rear Seats
Warning
A seat that is not locked into place
properly can move around in a collision
or sudden stop. People in the vehicle
could be injured. Be sure to lock the seat
into place properly when installing it.
Warning
A seat belt that is improperly routed, not
properly attached, or twisted will not
provide the protection needed in a crash.
The person wearing the belt could be
seriously injured. After raising the rear
seatback, always check to be sure that
the seat belts are properly routed and
attached, and are not twisted.
Seats and Restraints
1. Position the seat into the open slots in
both rails. Push the seat forward in the
rail, hooking both seat bases onto the
pins inside of the rails.
2. Locate the hole in the rail to install the
locking pins at the rear of the seat base.
If the vehicle is equipped with a vinyl
floor covering, pull the flap that has
been cut into the vinyl.
3. Insert the locking pins into the seat base
and push the seat to line up the pins
with the base.
On a three-passenger seat, the pin with
the black cap marked R must be
installed on the right side and the pin
with the gray cap marked L must be
installed on the left side.
On a four-passenger seat, the pins
marked R must be installed on the half
of the seat on the right side. The pins
marked L must be installed on the half
of the seat on the left side.
25