HP Vectra VL6 6 Supplementary Manual page 12

Replacing the Pentium II
Processor
Installing Accessories in the New Desktop Package
The Pentium II processor is contained on a module which is installed in a
socket on the system board. It is held in place by a bracket. There are two
plastic clips, one on the top of each pillar of the bracket, to prevent the
processor module from slipping out.
Plastic clips
Bracket pillars
To remove the old processor module:
1 Press the two plastic clips towards each other.
2 Carefully pull the processor module away from its connector on the
system board.
The heat-sink is supplied with the processor, and is bolted to it by the
manufacturer.
10
Heat-sink