Table of Contents
Advertisement
Omni mode
When the digital piano is turned on, the instrument is automatically set to "omni mode on", allowing MIDI information to be received
on all MIDI channels (1~16). When the MIDI Channel setting is used to specify a transmit/receive channel, the instrument will be set
to "omni mode off".
Multi-timbral mode and Split/Dual modes
• Using Split mode with Multi-timbral mode enabled
Notes played in the lower section of the keyboard will be transmitted on the channel that is 1 channel higher than the specified chan-
nel. For example, if the MIDI channel is set to 3, notes played in the lower section of the keyboard will be transmitted on channel 4. (If
the specified MIDI channel is 16, the lower section / layered part will be transmitted on channel 1.)
• Using Dual mode with Multi-timbral mode enabled
Notes played will be transmitted on two channels: the specified channel and the channel that is 1 channel higher. For example, if the
MIDI channel is set to 3, notes played on the keyboard will be transmitted on channels 3 and 4. (If the specified MIDI channel is 16, the
lower section / layered part will be transmitted on channel 1.)
Transmit Program Change Number
▋ Turning Transmit Program Number ON/OFF
With "Transmit PGM #" selected, press the [LEFT]/[RIGHT] button
to turn the setting ON or OFF.
▋ Sending a Program Number
With "Send PGM #" selected, press the [LEFT]/[RIGHT] buttons to
select the Program Number, then press the [2] button to send
the selected number.
Program Numbers in the range of 1~128 can be sent.
• The Transmit Program Number Change ON/OFF setting is effective until the power is turned off.
• Exclusive information is not sent if the Transmit Program Change Number setting is OFF.
• When using Dual or Split mode, On/Off information and sound type settings for are transmitted as exclusive data, however
program change numbers will not be transmitted. Program change numbers will be transmitted when Multi-timbral mode
is set to On1 or On2.
Local Control
▋ Setting Local Control
With "Local Control" selected, press the [LEFT]/[RIGHT] button to
turn the setting ON or OFF.
• The Local Control setting is effective until the power is turned off.
• The preferred Local Control setting can be stored to the Startup Setting memory for automatic selection when the
instrument is turned on. Please refer to Owner's Manual page 50 for more information.
♯
3
Advertisement
Table of Contents
