Testing Digital Safe; Locking The Safe; Unlocking The Safe; Preparing For Safe Anchoring - Honeywell 5403 User Manual

TESTING DIGITAL SAFE

It is Important to test your new safe to ensure proper operation by locking and unlocking using the
instructions below.

LOCKING THE SAFE

Note: Slide hand across the touchscreen on the Safe to activate the Safe. (Digital keys
are lit when activated).
1. Close the safe door (Figure 1).
2. Press the button on the touchscreen (Figure 2).
3. If the safe successfully locks, the Lock Icon will light up (Figure 3).
4. Check to ensure safe is locked by attempting to open the safe.
Figure 1

UNLOCKING THE SAFE

1. In the locked position (Figure 1) , enter the personal passcode (Default 1234) followed
by the button (Figure 2).
2. If the code is entered correctly, the Unlock Icon will light up (Figure 3).
3. Open the safe door (Figure 4).
4. You may also use the included Override Access key to unlock the safe. (see page 4).
Figure 1
PREPARE FLOOR FOR ANCHORING
NOTE: Bolting/unbolting of the unit is at the consumer's expense and discretion. LH Licensed
Products, Inc. is not responsible for any costs incurred if the unit has to be replaced. If you have
any questions about mounting the safe, please check with your local home center/hardware
retailer or independent contractor.
1. Select a suitable and convenient location for your safe.
2. Empty the safe.
3. Place your safe in the desired location for mounting.
4. Mark the drilling point on the surface with a pen or pencil through the holes.
5. Move the safe aside to clear the marked spot for drilling and proceed to page 4.
NOTE: If anchoring to a carpeted floor, cut a hole in the carpet at least 1" around the carpet to
expose the floor that you will be drilling.
Figure 2
Figure 2
Lock Icon
Figure 3
Unlock Icon
Figure 3
3
Figure 4