Table of Contents
Advertisement
SETUP AND OPERATION
STEP 1. OPEN SAFE WITH OVERRIDE KEY
1. Remove override key cover with small
screwdriver.
2. Insert override key and turn left to
unlock safe.
3. Turn knob to right and open safe door.
STEP 2. INSTALL BATTERIES
1. Remove battery compartment (A) cover
on inside door. Insert 4 "AA" batteries.
Ensure the batteries are installed in the
correct direction, with regard to polarity
(+ and -) See diagram.
2. Replace the battery cover.
3. Do not close door before testing digital lock.
TEST DIGITAL LOCK
1. With door open, turn knob left to put locking
door bolts (B) in lock position.
2. Remove override key and store in a secure place.
NEVER STORE KEYS INSIDE SAFE!
3. Enter the preset pass code: "1"-"5"–"9"-"B" .
4. Turn knob to right within 5 seconds.
5. Lock bolts should recede into the
unlocked position.
PROGRAM A NEW PASSCODE
1. With door open, remove the cap if applicable,
and press reset button (C) inside door.
2. Yellow light is on, enter new pass code
in 30 seconds.
3. Enter new code (3 to 8 digits) followed
by "A" or "B".
4. Safe will beep and yellow light will turn off.
NOTE: The factory pre-set code will not work after
a new pass code is programmed.
TO OPEN THE SAFE
1. To unlock and open safe, enter the pass code followed by "A" or "B".
2. Turn door entry knob to the right and open door.
TO CLOSE THE SAFE
1. Close the door and hold it in the closed position.
2. Turn door entry knob to left to engage the lock
bolts and lock safe.
C
2
1
2
3
4
5
6
7
8
9
A
0
B
B
A
B
Hide quick links:
Advertisement
Table of Contents
