Table of Contents
Advertisement
14
www.electrolux.com
3.4 Options
Water Level Button
Choose the water level by pressing "Water
Level" button.
Use only the amount of water you need for
the wash load.
Please refer to the program table on page
12.
Flood diagnostic is explained on
page 30. You should refer to this if
you have water pouring onto the
floorThe display will show "
you will hear rapid short beep
continuously to remind you about
this problem.
Soak Button
This option allows you to soak heavily
soiled clothes at the beginning of the
wash. To do this, press Soak button to
select the soak time.
The lid must be closed to allow Soak
functions to operate. The machine will
agitate for short periods. At other times,
the clothes are soaking and the machine
will be doing nothing.
Rinse Button
Pressing the Rinse button to choose the
rinse type for your wash load. For most
washes, the machine automatically fills
the full tub of water for a rinse.
There are four rinses to choose from
Extra, Regular, Fast and Hold.
Extra rinse
Regular rinse - 2 rinses cycles.
Fast rinse - 1 rinse cycle.
Hold, by selecting this option the water
of the last rinse is not emptied out and
the agitator turns every minute to
prevent the laundry creases.
" and
Spin Button
Press this button to select the spin speed
or no spin, if you want your laundry to be
spun at a speed different from the one
proposed by the washing machine.
The speed of spin level are:
– High, about 700 rpm ;
– Mid, about 650 rpm ;
– Low, about 550 rpm ;
– No Spin, 0 rpm.
.
You must drain the water from
the washing tub by pressing
"Start/Pause" button to continue
the cycle.
Alternatively, before pressing the
"Start/Pause", you can press the
"Spin" button to change the spin
speed. You can select "No Spin",
if you want the machine to only
drain the water.
NOTE
After approximately 18 hours, if
you do not press Start/Pause
button, the appliance will drain
and spin automatically.
Advertisement
Table of Contents
