Configuring Your Linux Personal Workstation - HP PL Class 450/500/550/600/650/700/750 Supplementary Manual

System Setup
Configuring Your Linux Personal Workstation
Configuring Your Linux Personal Workstation
Be sure that no disks are in the 3.5-inch floppy drive or the CD-ROM
drive, then turn on the power switch. As the workstation starts up
(boots), it describes what is happening with messages on the screen. You
do not need to respond to any messages you see. The start-up process is
completely automatic.
After a few minutes, the process ends and the monitor screen displays
important information about Year 2000 readiness of the HP V
ISUALIZE
Linux Workstation and the software installed on it. When you have read
this information, click OK at the bottom of the screen. The Linux Setup
Tool window, shown below, appears.
Choose the Boot Protocol appropriate for your system. If you do not know
which protocol to choose, ask your system administrator. The following
instructions assume you are using the "Static" protocol.
Chapter 1 3