Use; Connecting; Using The Adapter; Using The Spray Nozzle - Parkside 331866 1907 Assembly And Safety Advice

Use the included screws
rawlplugs . These are only
5
suitable when mounting to brick,
concrete- or wooden walls.
Please use suitable screws and
rawlplugs when mounting to
other materials. Consult your re-
tailer for rawlplugs and screws
suitable for the respective wall.
Note: To prevent backflow, do
not mount the hose holder
higher than the tap, or install a
backflow preventer or stop cock
between the tap and hose
For mobile use, the spray head
and the hose connections
1
can be inserted into the brackets
on the left and right.
Attention: For wall installation,
hang the spray head as shown
in Fig. D.

Use

Connecting

Connect the hose
in Figure B.
and
4
7
.
6
as shown
6

Using the adapter

Rotate the tap connector
clockwise onto the connection
thread of the tap.
The adapter
2b
a ½ (12.7 mm) connection
thread.
Rotate the adapter
into the tap connector

Using the spray nozzle

Note: the spray nozzle
ten different spray patterns. The flow
rate is variable.
Insert the spray nozzle
hose connector with water stop
(cf. Fig. C).
Move the trigger switch
the back to start water flow and
for variable adjustment (cf. Fig. D).
Turn the wheel
to select or adjust the spray pat-
tern (cf. Fig. D). You can choose
between ten different settings: jet
stream, shower spray, fan spray,
central spray, soaker spray, verti-
cal spray, scattered spray, mist,
flat spray, cone spray.
2a
must be used for
clockwise
2b
.
2a
features
1
in the
1
3
to
1a
to position „ ",
1b
GB/IE/NI 9