Helpful Hints Page 3 • Use only Tablet or Pebble Salt. Warranty T&C's Page 4 (re-order your salt via www.watercare.co.uk) Extended Warranty Page 5 • Check the salt level regularly and ensure it does not fall below the water level.
- Freezing of softener, water pipes or drain pipes. - High water pressure. Max 5 bar pressure, exceeding 5 bar will void warranty. (WaterCare recommends fitting a pressure reducing valve should pressure exceed 3 bar) - Blocking or kinking of supply or drain hoses.
INSTALLATION GUIDE INSTALLATION INSTRUCTIONS To-By-Pass softener in case of technical fault: Close inlet and outlet EASY SET UP INSTALLATION OF YOUR NEW SOFTENER isolation valve to softener and open By-pass valve on mains supply - Reverse to reconnect softener. Before beginning installation please ensure: 1) Pressure reducing valve is fitted to pipe work if site pressure is over 3 bar.
SOFTENER SET UP SET DAY OF WEEK. The day indicator will be flashing. Press to adjust value. SET TIME. Press to save value and move on to next step. Press 07 will be flashing, recommended to leave on 07. (7 day regeneration override) Press to save value and move on to next step.
SET THE INCOMING HARDNESS (DEFAULT 300PPM) The indicator will be flashing. Press to adjust value. To register your new WaterCare Home softener please visit: Press to save value and move on to next digit. www.watercare.co.uk/water-softener-reg Repeat until correct value is displayed.
If you have any queries please contact us... WaterCare Home Regal House South Road Harlow CM20 2BL Telephone: 01279 780250 HOME Email: info@watercare.co.uk HOME www.watercarehome.co.uk v1.0...