Table of Contents
Advertisement
9. Remove the three transit bolts and pull out
the plastic spacers.
We recommend that you
keep the packaging and
the transit bolts for any
movement of the
appliance.
3.2 Information for installation
1. Positioning and levelling
Correctly adjusting the appliance so that
it is level prevents vibration, noise and
movement of the appliance when in
operation.
1. Install the appliance on a flat hard
floor. The appliance must be level and
stable. Make sure that the appliance
does not touch the wall or other units and
there is air circulation below the
appliance.
2. Loosen or tighten the feet to adjust the
level. All feet must rest firmly on the floor.
10. Put the plastic caps, that you find in the
user manual bag, in the holes.
2. The inlet hose
x4
WARNING!
Do not put cardboard, wood
or equivalent materials
below the appliance feet to
adjust the level.
Refer to Stacking kit chapter.
When the machine is
installed on a plinth or if a
washer dryer is stacked on
the washing machine, use
the accessories described in
chapter 'Accessories'. Read
carefully the instructions
supplied with the appliance
and with the accessory.
CAUTION!
Make sure there is no
damage to hoses and there
are no leaks from the
couplings. Do not use an
extension hose if the inlet
hose is too short. Contact
the service centre for a
replacement inlet hose.
ENGLISH
7
Advertisement
Table of Contents
