Sharp SF-2220 Service Manual page 123

Main code Sub code
26 06 Destination setting
07 Drum sensitivity setting
10 AE original density setting
13 Warm-up mode setting
18 Toner save mode setting (Japan/SUK only)
Used to set the destination (Japan, SEC, etc.).
When this simulation is executed, the currently set destination is displayed on the copy quantity display.
Enter the set value and press the PRINT button to store it.
Set value Destination
0 Japan
1 SEC
2 SECL
3 SEEG
4 SUK
5 SCA
6 EX inch series
7 EX AB series
8 EX inch series (FC)
9 EX AB series (FC)
10 Taiwan/China
Used to set the drum sensitivity.
When this simulation is executed, the currently set drum sensitivity is displayed on the copy quantity display.
Enter the set value and press the PRINT button to store it.
Set value Drum sensitivity
1 1
2 2
3 3
Used to set the original density.
When this simulation is executed, the currently set original density is displayed on the copy quantity display.
Enter the set value and press the PRINT button to store it.
Set value Original density
0 Normal
1 Thin original
When a dark original is copied in the AE mode, the lead edge (about 4mm) is not copied. If it is necessary to copy
the lead edge, set this simulation to "1."
Used to set the main motor operation mode during warm-up.
When this simulation is executed, the currently set warm-up mode is displayed on the copy quantity display.
Enter the set value and press the PRINT button to store it.
Set value
0 Normal mode
1 The main motor rotates until warm-up is completed.
Used to set ON/OFF of the toner save mode.
When this simulation is executed, the currently set value is displayed on the copy quantity display.
Enter the set value and press the PRINT button to store it.
Set value Toner save mode
0 ON
1 OFF
Content
← Initial value
← Initial value
Warm-up mode
← Initial value
8 – 10
← Initial value