Network Configuration; Network Connection - Hall Technologies HT-CAM-1080PTZ User Manual

4. Network Configuration

4.1 Network Connection

Direct connection: Connect the camera and computer using a network connecting cable.
Internet connection mode: Connect the camera to the Internet by Router or Switch and the
user can then login to the device by browser web page.
Note: Please do not put the power cable and network cable in places where they can be easily
touched, to prevent an unstable video signal transmission due to poor contact of cables.
The computer must have the same IP range that the camera IP has. The device will not be
accessible if it is not on the same range.
The camera default IP address is 192.168.5.163, therefore the computer needs to be on the
same 192.168.5.xxx range.
Firstly, open the window of Local Area Connection Properties on computer, select the "Internet
protocol version 4(TCP/IPv4)". Double click or click the property "Internet" protocol version 4
(TCP/IPv4) to enter into the Internet Protocol Version 4(TCP/IPv4) Properties window; select
"Advanced" to enter into the Advanced TCP/IP Setting and add IP and subnet mask. Click the
"Confirm" to finish the adding of IP range/segment. User can add the corresponding network
IP range/segment according to the same IP range/address of the camera.
Note: The IP address to be added cannot be same as any other computers or devices on the
network. The existence of this IP address needs to be verified before adding.
To verify whether the network segment has been successfully added, for Windows 10 users, in
the search bar type cmd, then press return. This will open the DOS command window. Type in
ping 192.168.5.26 and press Enter key to display information as shown below:
Hall Technologies March 2, 2022 Page 25 of 41