Advertisement
The tool can be plugged into any socket-outlet (with 230V AC) that is equipped with a
10A fuse or higher. The socket-outlet has to be safeguarded by an RCD (Residual Current
Device). The operating current of the RCD must not exceed 30mA.
1. Secure the power
cable with the
strain-relief clip
found on the
equipment.
– Select desired length of cable required, form a loop
and feed through ring on rear handle (7)
– Secure cable over strain relief clip (15)
2. To switch on the equipment press in the safety interlock
(2) button and press and hold the On/Off trigger (6).
To switch off, release the On/Off (6) trigger.
One wire brush (8) and one nylon brush (9) are supplied with the equipment. The wire
brush is suited for use on robust surfaces and obstinate weeds. We recommend using the
nylon brush for light vegetation and surfaces too sensitive for the wire brush (which can be
used for tougher debris).
iMPortAnt:
Always carry out a short trial run to check out possible effects on the surfaces of the
paving stones or slabs before starting with your work. Never use the equipment on very
sensitive surfaces, for example tiles.
iMPortAnt:
Only use brushes which are in good condition. Replace excessively worn or damaged
brushes immediately.
•
Always use both hands to operate the equipment.
•
Guide the equipment along the joints at a walking pace.
•
For uniform results, carry out your work at a constant speed.
•
If necessary, guide the equipment along the same joint several times.
replacing the power cable
If the power cable for this equipment is damaged, it must be replaced by a qualified
engineer to ensure its continued safety in use.
AFTER SALES SUPPORT '8 0871 911 7031 Q CUSTOMERSERVICE@GARDENGEARONLINE.CO.UK
instructions for use
9
Advertisement
