Advertisement
instructions for use
Before you connect the equipment to the power supply, make sure that the data on
the rating plate is identical to your local mains supply voltage. Always pull out the
power plug before making adjustments to the equipment.
1. Insert the top half of the housing into the bottom half and click into place.
2. Insert the guide wheel (4) into the opening on the main housing. Make sure that there
is an audible click when it engages.
3. Clip on the guard hood (3) as shown and secure with 2 screws. Fit the brush
(8 or 9) onto the drive axle. Make sure that the brush fits accurately into the mount. The
M8 (11) nut must be fitted and tightened on the end of the shaft in order to fasten the
brush. To do so, insert the rod into the recess on the shaft and hold with one hand. Use
the open-ended wrench to secure the nut.
iMPortAnt:
Once the brush is attached be sure to remove the rod from the shaft. To remove or
change the brush follow these instructions in reverse order.
AFTER SALES SUPPORT '8 0871 911 7031 Q CUSTOMERSERVICE@GARDENGEARONLINE.CO.UK
8
Advertisement
