Bauhn AMAB-0622-D Installation Manual

Have you got everything?
K
L
M
Unpack the box (be gentle) and make sure all of these items are there:
A. Pole
B. Monitor Arms
C. M4 x 8mm Screws (8)
D. M4 x 12mm Screws (8)
Attach the arm
Slide the bracket arms
onto the pole. Slide up
or down to adjust the
height of where your
monitors will sit.
Tighten into position
at the back, using the
supplied 5mm hex key.
Installation Guide
Hey!
Let's get your new monitor
bracket ready to use, fast!
x 8 x 8
x 3
N
x 4
E. Screw Spacers (8) I. Bracket Clamp Cover
F. 4mm Hex Key J. Cap Screw (3)
G. 5mm Hex Key K. Bracket Clamp
H. Pole Cover L. Pole Cable Clip
Adhere the bracket clamp cover to the bracket clamp
and attach the clamp to the base with the cap screw.
Tighten the bracket clamp from beneath by turning
the adjuster clockwise and make sure it's tight.
Slide the base cover on and clip into place.
Be careful not to overtighten the clamp or you
might cause surface damage to your desk or table
Model: AMAB-0622-D
Dual Monitor Bracket
x 8
O
Attach to your desk
(Mounting to edge of desk)
Use the 4mm hex key to tighten.
You will also need
a Phillips-head
screwdriver
to secure your
monitors to the
bracket
P
M. Monitor Arm Cable Clips (4)
N. Warranty Certificate
O. General Safety Warnings
P. Installation Guide
Nearly done!
Just a bit more
on the other side
of this page...