Bauhn AMAB-0619-S Quick Start Manual

Have you got everything?

J
L
Unpack the box (be gentle) and make sure all of these items are there:
A. Bracket
B. Bracket clamp
C. M4 x 8mm screws (x4)
D. M4 x 16mm screws (x4)
1
2
3

Attach to your desk

(mounting to desk cable opening)
Loosen the two screws that connect the two parts of
the clamp.
Put the arm through the hole in your table.
Install the lower part of the
clamp with the two screws.
Tighten the clamp until it is
securely fastened to the desk.
Quick Start Guide
Hey!
Let's get your new monitor
bracket ready to use, fast!
F
H
K
E. Screw spacers (x4)
F. 4mm hex key
G. 5mm hex key
H. Cap screws (x3)
Attach to your desk
Attach the clamp to the base with the 3 flat cap
screws. Use the 4mm hex key to tighten.
Adhere the mounting plate bolt cover to the
base and adhere the bracket clamp cover to the
Tighten the securing bracket by turning the adjuster
clockwise and make sure it's tight. If your desk is too
thick, adjust the clamp down a notch and re-tighten.
Be careful not to overtighten the clamp or you might cause
surface damage to your desk or table
I
M
I. Bracket clamp cover
J. Bracket cover
K. Mounting plate bolt cover
L. Cable cover
(mounting to edge of desk)
1
Model: AMAB-0619-S
You will also need
a Phillips-head
screwdriver
to secure your
N
monitors to the
bracket
M. Warranty Card
N. Quick Start Guide
support block.
3
Nearly done!
Just a bit more
on the other side
of this page...
2