Bauhn ADMAB-0222 Installation Manual

Have you got everything?

UP
M
N
N
Unpack the box (be gentle) and make sure all of these items are there:
A. Dual Gas Spring D. M4 x 8mm Screws (8)
Monitor Bracket with E. M4 x 12mm Screws (8)
USB ports F. Screw Spacers (8)
B. Bracket Clamp G. M5 Nut (4)
C. Laptop Holder H. M6 x 12mm Cap Screws (3)
1
2
3
Attach to your desk
(mounting to desk cable opening)
Loosen the two screws that connect the two parts of
the clamp.
Put the arm through the hole in your table.
Install the lower part of the
clamp with the two screws.
Tighten the clamp until it is
securely fastened to the desk.
Installation Guide
Gas Lift and Laptop Holder
Hey!
Let's get your new monitor
bracket ready to use, fast!
UP
G
F
x 4
x 8
J K
O
x 2
Attach the bracket clamp to the base with the 3 M6 x
12mm cap screws. Use the 4mm hex key to tighten.
Adhere the bracket cover and the bracket clamp
cover to the support block of the bracket clamp.
the adjuster anti-clockwise and make sure
it's tight. If your desk is too thick, adjust the
Be careful not to overtighten the clamp or you Be careful not to overtighten the clamp or you
might cause surface damage to your desk or table might cause surface damage to your desk or table
Model: ADMAB-0222
Dual Monitor Arm with
x 8
x 8
H I
x 3 x 4
Q
P
I. M5 x 12mm Cap Screws (4)
J. 4mm Hex Key
K. 5mm Hex Key
L. Bracket Cover
M. Bracket Clamp Cover
Attach to your desk
(Mounting to edge of desk)
Tighten the securing bracket by turning
clamp down a notch and re-tighten.
You will also need
a Phillips-head
screwdriver
to secure your
monitors and the
laptop holder to
the bracket
N. Cable Cover (2)
O. Warranty Certificate
P. General Safety Warnings
Q. Installation Guide
1
3
Nearly done!
Just a bit more
on the other side
of this page...
2