Auto Turn Off; Timer; Object Detected Over Keypad Indicator; Hot Surface Indicator - Sharp SCH2443GB Operation Manual

USING THE COOKTOP
PAUSE COOKING/TIMER
Touch the PAUSE ALL keypad for 1 second. A tone will sound
and the displayed settings for each heater/timer in use will blink.
RESUME COOKING TIMER
Touch the PAUSE ALL keypad for 1 second. A tone will sound,
indicating cooking or timer operations have resumed, and
displayed settings for each heater/timer in use will remain on.
NOTE: If the PAUSE ALL keypad is not touched again within
10 minutes to resume cooking/timer operation, the heaters/
timers will automatically turn OFF.

AUTO TURN OFF

If a power level is not changed during operation, each heater
will power down a level once the time on the chart has elapsed.
POWER LEVEL
1
2
3
4
5
6
7
8
9
P
MELT
WARM
SIMMER
OBJECT DETECTED OVER KEYPAD
INDICATOR
If any objects are detected over the keypads for longer than 10
seconds, all heaters will automatically turn OFF and the displays
will blink . The will remain blinking in the displays until
objects are removed from the keypads.

TIMER

The automatic timer settings range from 1 minute to 99 minutes.
The final minute will count down in seconds on the display.
POWER
LEVEL
IMPORTANT: The timers DO NOT control heaters or turn
them off at the end of the countdown.
E
POWER DOWN TIME
10 hours
5 hours
4 hours
4 hours
3 hours
2 hours
2 hours
2 hours
1 hour
10 minutes
2 hours
5 hours
5 hours
TIMER
TO SET THE TIMER
1 Select desired heater for timer to be set (compatible cookware
must be placed and power level must already be set) and touch
TIMER keypad. A tone will sound and the numbers 00 and
the word TIMER will blink on the display.
2 Touch the + and – keypads to set the desired countdown
time. A tone will sound each time a power level is increased
or decreased.
Holding the + key will increase the speed at which numbers
display until 99 is reached. The maximum number of minutes
that may be set is 99 minutes. If the + keypad is touched after
99 is displayed, timer input will not be changed.
To decrease a time input, touch the – keypad. Holding the –
keypad will increase the speed at which numbers display and
decrease until 00 is reached. If the – keypad is touched again,
99 minutes will be set.
Countdown time is accepted 5 seconds after the last + and –
keypad is touched. A tone will sound and the digits and word
TIMER will stop blinking and remain illuminated. If a time
greater than 00 is not set within 5 seconds of touching the
TIMER keypad, the Timer function will automatically turn OFF.
TO ADJUST THE TIMER DURING USE
Touch the TIMER keypad and use the + and – keypads to set
the new time.
TO CANCEL THE TIMER
1 Select designated timer to be canceled.
2 Touch and hold the TIMER keypad for 3 seconds. A tone
will sound and the digits and word TIMER will clear from
the display.
IMPORTANT: Canceling a timer DOES NOT TURN OFF
the heater in use.

HOT SURFACE INDICATOR

Heaters can remain hot after cooking has completed and the
cookware has been removed.
If the power level is set to 0 and the heater is still ON, the display
will blink and alternate between 0 and H to indicate residual
heat until the heater has cooled.
If the heater has been turned OFF, the display will blink H to
indicate residual heat until the heater has cooled.
In the event of a power failure to the home or to
WARNING
the cooktop, be aware that SURFACES OF HEATERS WILL
REMAIN HOT even though the Hot Surface Indicator is not
displayed. The Hot Surface Indicator will not automatically
illuminate once power is restored.
14