Sound Settings; Viewing The Software Settings - HP P Class 733/800/866MHz / 1GHz Online Manual

Sound Settings

The embedded audio in your HP PC Workstation supports Plug and Play. This
means that if another accessory board is installed, or reinstalled, the operating
system is able to automatically configure the various software settings.
The following table gives the preferred settings for the embedded audio:
Audio Interface:
MPU-401 UART MIDI Interface:
Joystick Interface:
Stereo Music Synthesizer
The operating system may change these settings when a board is installed or
reinstalled in the following situations:
•
•

Viewing the Software Settings

All of the embedded audio settings are software configurable.
Viewing the Software
You can view the software settings as follows:
Settings Under
1
Windows NT 4.0
2
Another peripheral device uses the same I/O addresses, DMA channel, or
interrupt setting as the embedded audio (known as a hardware conflict).
Another joystick/game connector is already in use in your system.
Click the Start button and select Settings
Open Multimedia
I/O Address Range: 100H to 3F0H
Joystick Connector: Enabled
IRQ Line: 5, 7, 9, 11, 12, 15
DMA Channel 1: 0, 1, 3
DMA Channel 2: 0, 1, 3
I/O Address Range: 100H to 3FEH
IRQ Line: 5, 7, 9, 11, 12, 15
I/O Address Range: 100H to 3F8H
I/O Address Range: 100H to 3F0H
Control Panel.
and click the Devices tab.
Using Sound on Your PC
Sound Settings
English 17