HP P Class 450/500/550/600/650/700/750 Supplementary Manual page 16

ELSA SYNERGY II and GLoria II Graphics Cards
Installing, Updating and Configuring the Cards
6. Remove the AGP accessory slot screw from the bulkhead.
7. Remove the bulkhead filler panel from the AGP slot.
NOTE
Your Personal Workstation may look different than the one documented here.
8. Grasp the graphics card's bulkhead and opposite edge and align the card's contact
fingers with the AGP or AGP Pro connector on the system board. Ensure that the card's
contact fingers are fully seated in their connectors.
16
AGP or AGP Pro Connector
Chapter 1