Advertisement
10. OPERATING INSTRUCTIONS
WARNING: This solar charger must be properly assembled in accordance with the assembly instructions before it is used.
The solar charger does not have an ON/OFF switch. The On and Off commands are controlled by placing the solar charger in the sun only after the battery connections
have been made.
You MUST disconnect the solar charger from the battery when starting the engine or driving the vehicle. Electrical surges from the alternator when starting and running
may damage the solar panel.
NOTE: The clamps are always live.
CHARGING A VEHICLE BATTERY
1. Ensure that all of the solar charger components are in place and in good working condition, for example, the plastic boots on the battery clamps.
2. Connect the battery clamps to the solar charger, making sure the connection is secure.
3. Connect the battery following the precautions listed in sections 6 and 7.
4. Place the solar charger in the sun. For optimum solar panel output, face the front (glass) side of the solar panel towards the sun, making sure there are no shadows
being cast on the panel by the vehicle or other objects. The best orientation to place the solar panel is in a south to north direction with the panel tilted at a suitable
angle. The best angle would be the same as your local latitude.
5. To disconnect, reverse the procedure.
NOTE: This unit charges small batteries and maintains large batteries (12 volt or less), keeping them at full charge. However, if you were to use this unit to charge a large
battery, you may lose some of the battery's capacity. This would cause the battery to be unable to hold a charge and become useless.
NOTE: This is a manual charger and will overcharge a battery if permitted to operate for extended periods of time. Monitor charging often, as not doing so may cause
damage to your battery, or result in other property damage or personal injury.
NOTE: The USB and battery clamp outputs cannot be used simultaneously. If the USB output is connected for charging, the unit will not maintain a vehicle battery.
WARNING: The manufacturer strongly recommends using a solar charge controller (p/n 940261073, sold separately) in tandem with this solar charger for optimal results
and to avoid overcharge or discharge of the battery.
USING THE QUICK-CONNECT BATTERY CLAMPS
1. Connect the battery clamp cable assembly to the solar charger. Do not place on wet ground, anywhere it could be accidently stepped on or in a place or position where
it could fall while being used. Never use the output cable for other applications, as reverse polarity and/or overcharge conditions will occur.
2. Follow the steps in sections 6 and 7 to connect the output clamps to the battery.
3. After a good electrical connection is made to the battery, place the solar charger in the sun, per the instructions in step 4 of the Charging a Vehicle Battery section.
11. MAINTENANCE INSTRUCTIONS
11.1 After use and before performing maintenance, unplug and disconnect the solar charger (see sections 6, 7 and 8).
11.2 Use a dry cloth to wipe all battery corrosion and other dirt or oil from the battery clamps, cords and the solar panels.
11.3 The solar panels use a glass substrate; handle with care.
11.4 Always keep the glass surface clean using a soft cloth in order to ensure its maximum output.
11.5 Ensure that all of the solar charger components are in place and in good working condition, for example, the plastic boots on the battery clamps.
11.6 Servicing does not require opening the unit, as there are no user-serviceable parts.
11.7 All other servicing should be performed by qualified service personnel.
12. MOVING AND STORAGE INSTRUCTIONS
12.1 Unplug the solar charger and fold before storing.
12.2 Store inside, in a cool, dry place.
12.3 Do not store the clamps clipped together, on or around metal, or clipped to cables.
12.4 If the solar charger is moved around the shop or transported to another location, take care to avoid/prevent damage to the cords, clamps and solar panels. Failure to do so
could result in personal injury or property damage.
13. SPECIFICATIONS
Solar technology ..............................................................................................................Monocrystalline
Power output ................................................................................................................ 5W max @ 5-16V
Tested under standard conditions ..................................................................... AM1.5, 1000W/m
Operating temperature ............................................................................... - 4° F–185° F ( - 20° C–85° C)
USB port ......................................................................................................................................One, 1A
Dimensions, folded ...........................................................................................7.28 x 4.53 x 0.79 inches
Dimensions, unfolded .....................................................................................15.35 x 7.09 x 0.12 inches
14. ACCESSORIES
Solar charge controller ............................................................................................................940261073
15. BEFORE RETURNING FOR REPAIRS
For REPAIRS OR RETURNS, visit 365rma.com
Visit batterychargers.com for Replacement Parts.
16. LIMITED WARRANTY
For information on our one year limited warranty, please visit batterychargers.com or call 1-800-621-5485 to request a copy.
Go to batterychargers.com to register your product online.
, 25°C
2
• 3 •
Advertisement
