Canon Pro9000 Mark II Service Manual page 45

Bottom plate Perform via the
cleaning Resume/Cancel button, or
from the printer driver
Maintenance tab.
4-2. Service Mode
(1) Service mode operation procedures
Use the Service Tool on the connected computer.
1) Start the printer in the service mode.
i. With the printer power turned off, while pressing the Resume/Cancel button, press and hold the Power
button. (DO NOT release the buttons.)
ii. When the Power LED lights in green, while holding the Power button, release the
Resume/Cancel button. (DO NOT release the Power button.)
iii. While holding the Power button, press the Resume/Cancel button 2 times, and then release
both the Power and Resume/Cancel buttons. (Each time the Resume/Cancel button is pressed,
the Alarm and Power LEDs light alternately, Alarm in orange and Power in green, starting
with Alarm LED.)
iv. When the Power LED lights in green, the printer is ready for the service mode operation.
2) Start the Service Tool on the connected computer.
i. When a button is clicked in the Service Tool dialog box, that function is performed. During operation
of the selected function, all the Service Tool buttons are dimmed and inactive.
ii. When the operation is completed, "A function was finished." is displayed, and another function
can be selected.
iii. If a non-supported function is selected, "Error!" is displayed. Click OK in the error message
dialog box to exit the error.
rollers will wear out in this cleaning, it is
recommended that you perform this only when
necessary.
5 times Cleaning of the platen ribs when the back side of
paper gets smeared.
Fold a sheet of plain paper (A4 or Letter) in half
crosswise, then unfold and set it in the rear tray
with the folded ridge facing down. (No paper
feeding from the front tray)
42 / 56