Canon Pro9000 Mark II Service Manual page 19

18 times Spur base lift
mechanism
error
19 times Ink tank
position
sensor error
20 times Other errors [6500]
Before replacement of the logic board ass'y, check the ink absorber counter value (by
service test print or EEPROM information print). If the counter value is 7% or more,
also replace the ink absorber kit when replacing the logic board ass'y. If the counter
value is less than 7%, register the current ink absorber counter value to the replaced new
logic board instead. [See
setting, for details.]
[5120] The spur base did not
move up or down
properly.
[6502] None of the ink tank
position is detected.
An unidentified error or a
network error occurred.
4-4. Special Notes on Servicing, (5) Ink absorber counter
paper path;
remove foreign material.
(3) Cable connection
(4) Part replacement:
- EJ slit disk film
- LF / EJ timing sensor unit
- Platen unit
- Logic board
- Paper feed motor
(1) Cable connection
(2) Part replacement:
- ASF unit
- Spur base lift unit
- Logic board
(1) Ink tank position;
confirm the ink tank position.
(2) Re-set or replacement of ink tanks
(3) Cable connection
(4) Part replacement:
- Ink tank position sensor error
- Logic board
(1) Part replacement:
- Logic board
16 / 56