Subscribe to Our Youtube Channel
Related Manuals for Nice MYGO4
Summary of Contents for Nice MYGO4
- Page 1 Nice MYGO MYGO/A MYGO4 MYGO8 MYGO4/A MYGO8/A One-way transmitters EN - Instructions and warnings for installation and use...
-
Page 2: Table Of Contents
– The batteries must be disposed of in a safe way. – The manufacturer of this appliance, Nice S.p.A., hereby de- clares that the product complies with Directive 2014/53/EU. – The instruction manual and the full text of the EU Declaration of Conformity are available at the following Internet address: www.niceforyou.com, under the “support”... -
Page 3: Product Description And Intended Use
MYGO8 - MYGO8/A Red signalling LED Hole for unlocking and removing the rear shell Control buttons area for models MYGO4 (MYGO4/A) Control buttons area first sector (*) for models MYGO8 (MYGO8/A) Control buttons area second sector (*) for models MYGO8 (MYGO8/A) (*) Each sector can be regarded as if it were an independent transmitter. -
Page 4: Memorising The Transmitter
3.2.4 MEMORISATION THROUGH THE “ENABLING CODE” MEMORISING THE TRANSMITTER (BETWEEN AN OLD TRANSMITTER ALREADY MEMORISED AND A NEW TRANSMITTER) MEMORISING THE TRANSMITTER The MYGO (MYGO/A) transmitter has a secret code, the so-called “ENABLING CODE”. By transferring this code from a memorised 3.1 TRANSMITTER VERIFICATION transmitter to a new transmitter, the latter is recognised (and memo- Before memorising the transmitter in the automation’s receiver, en-... -
Page 5: Encoding Switch Procedure
On the OLD transmitter, press and hold any button, within the ENCODING SWITCH PROCEDURE desired sector, until LED (B) of the NEW transmitter switches on. Subsequently, release the button (LED (B) of the NEW trans- mitter will turn off to signal that the procedure has terminated ENCODING SWITCH PROCEDURE MYGO (MYGO/A) transmitters operate by default with the one-way and the “enabling code”... -
Page 6: Replacing The Battery
REPLACING THE BATTERY PRODUCT DISPOSAL REPLACING THE BATTERY PRODUCT DISPOSAL When the battery is flat and a button is pressed, the corresponding This product is an integral part of the operator and signalling LED fades and the transmitter will not transmit. With the bat- tery almost flat, the signalling LED emits red flashes during the trans- must therefore be disposed of with it. -
Page 7: Technical Specifications
CONFORMITY 8.1 SIMPLIFIED EU DECLARATION OF CONFORMITY The manufacturer, Nice S.p.A., declares that the product MYGO4 - MYGO8 is compliant with the directive 2014/53/UE. The full text of the EU declaration of conformity is available at the fol- lowing internet address: https://www.niceforyou.com/en/support. - Page 8 Nice SpA Via Callalta, 1 31046 Oderzo TV Italy www.niceforyou.com info@niceforyou.com...
Need help?
Do you have a question about the MYGO4 and is the answer not in the manual?
Questions and answers