global_main.book.book Page 24 Thursday, February 10, 2022 10:27 AM
INSTALLATION
24
NOTE
• Deduct 1.8 m for each additional elbow. Do not use more than four 90° elbows.
Routing and Connecting
Ductwork
Follow the guidelines below to maximize drying
performance and reduce lint buildup and
condensation in the ductwork. Ductwork and
fittings are NOT included and must be purchased
separately.
• Use 10 cm diameter rigid, semi-rigid or flexible
metal ductwork.
• The exhaust duct run should be as short as
possible.
• Use as few elbow joints as possible.
• The male end of each section of exhaust duct
must point away from the dryer.
• Use duct tape on all duct joints.
• Insulate ductwork that runs through unheated
areas in order to reduce condensation and lint
buildup on duct surfaces.
• Incorrect or inadequate exhaust systems are not
covered by the dryer warranty. Dryer failures or
service required because of such exhaust
systems will not be covered by the dryer
warranty.
Correct Venting
Connecting Gas Dryer
• To reduce the risk of fire or explosion, electric
Electrical Requirments for Gas
Models
• This dryer is equipped with a three-prong
• Do not, under any circumstances, cut or remove
• For personal safety, this dryer must be properly
• This dryer must be plugged into a 120-VAC, 60-
Incorrect Venting
• Where a standard 2-prong wall outlet is
Gas Supply Requirements
• DO NOT attempt any disassembly of the dryer;
WARNING
shock, property damage, injury to persons, or
death when using this appliance, follow
requirements including the following:
WARNING
grounding plug for protection against shock
hazard and should be plugged directly into a
properly grounded three-prong receptacle. Do
not cut or remove the grounding prong from this
plug.
the third (ground) prong from the power cord.
grounded.
Hz. grounded outlet protected by a 15-ampere
fuse or circuit breaker.
encountered, it is your personal responsibility
and obligation to have it replaced with a properly
grounded 3-prong wall outlet.
WARNING
disassembly requires the attention and tools of
an authorized and qualified service technician or
company.