Philips 4010W Series Service Manual page 22

EN 22 4. TPM15.3HE LA
4.4.4 Speakers
1. Gently release the tapes that secures the speaker cables.
2. Unplug the speaker connectors from the SSB.
3. Take the speakers out.
When defective, replace the both units.
4.4.5 Stand bracket
1. Remove all fixation screws of the bracket.
2. Lift the bracket from the set.
4.4.6 IR/LED Board
1. Unplug the connector from the IR/LED board.
2. Gently release the clip that holds the board and take it out
from the bezel.
When defective, replace the whole unit.
4.4.7 Option Board
1. Unplug the connector from the SSB.
2. Remove fixation screw that secure the Option board, gently
remove the board from the set.
When defective, replace the whole unit.
4.4.8 LCD Panel
1. Remove the stand as described earlier
2
2
2
4.5.2 Keyboard Control unit
1. Gently release the tapes that secure the keyboard cable.
2. Remove the fixation screws that secure the keyboard
control panel.
3. Gently take the keyboard out.
When defective, replace the whole unit.
2015-Otc-09
Mechanical Instructions
2
2
1
2
1
Figure 4-17 Rear cover removal
2. Remove the SSB as described earlier.
3. Remove the PSU as described earlier.
4. Remove the speakers as described earlier.
5. Remove the IR/LED board as described earlier.
6. Remove the Option board as described earlier.
7. Remove all other metal parts that do not belong to the LCD
panel.
8. Release all fixing clips that secure the front bezel to the
LCD panel.
9. Lift the LCD Panel from the front bezel.
When defective, replace the whole unit.
4.5 Assembly/Panel Removal (for 32"/40"/48"/55"
3010/5010/5110 series)
Instructions below apply to the 32HFL5010T/12, but will be
similar for other 32"/40"/48"/55" models.
4.5.1 Rear Cover
Refer to Figure 4-17
Warning: Disconnect the mains power cord before removing
the rear cover.
1. Remove fixation screws [1] that secure the base assy, pull
out the base assy from the set. Then remove the fixation
screws [2],[3],[4] that secure the rear cover. Refer to
Figure 4-17
2. Gently lift the rear cover from the TV. Make sure that wires
and cables are not damaged while lifting the rear cover
from the set.
2
1
1 2
4.5.3 Small Signal Board (SSB)
Refer to Figure 4-18
Caution: it is mandatory to remount all different screws at their
original position during re-assembly. Failure to do so may result
in damaging the SSB.
back to
div.table
for details.
for details.
2 2
3
4
for details.
2
2
19820_110.eps