Electrical heating unit with integrated temperature controller (12 pages)
Summary of Contents for Helios easyControls 3.0
Page 1
BEDIENUNGSANLEITUNG OPERATING INSTRUCTIONS NOTICE DE MONTAGE ET D’UTILISATION easy Controls 3.0 Erweiterungsmodul für easyControls 3.0 Extension module for easyControls 3.0 Module d’extension pour easyControls 3.0 KWL-EM eC zur Ansteuerung von externen Heizregistern for controlling heater batteries pour la commande de chauffage...
Bedienungsanleitung Erweiterungsmodul KWL-EM eC für easyControls KAPITEL 1 1�1 Wichtige Informationen ALLGEMEINE HINWEISE Zur Sicherstellung einer einwandfreien Funktion und zur eigenen Sicherheit sind alle nachstehenden Vorschriften genau durchzulesen und zu beachten. Nationale einschlägi- gen Normen, Sicherheitsbestimmungen und Vorschriften (z.B. DIN EN VDE 0100) sowie die TAB des EVUs sind unbedingt zu beachten und anzuwenden.
Alle Ausführungen dieser Dokumentation müssen beachtet werden, sonst entfällt die Gewährleistung. Gleiches gilt für Haftungsansprüche an Helios. Der Gebrauch von Zu- behörteilen, die nicht von Helios empfohlen oder angeboten werden, ist nicht statthaft. Eventuell auftretende Schäden unterliegen nicht der Gewährleistung. Veränderungen und Umbauten am Gerät sind nicht zulässig und führen zum Verlust der Konformität, jegliche...
KWL-EM eC mit geeignetem Befestigungsmaterial durch die vorhanden Schraubenöff- MONTAGE nungen in den Ecken des Gehäuses an der Wand befestigen. Ausrichtung des KWL-EM eC mit Helios Schriftzug nach unten� HINWEIS ⓘ Die neueste Version der Betriebsanleitung kann auf HeliosSelect unter www�HeliosSelect�de bei dem entsprechenden Artikel heruntergeladen werden�...
Montage- und Betriebsvorschrift Erweiterungsmodul KWL-EM eC für easyControls Es sind die in Kapitel 1�2, 1�3 aufgeführten Sicherheitshinweise zu beachten! WARNUNG 1. Gehäusedeckel öffnen. 2. Kabelverschraubungen auf Anschlusskabel auffädeln (rechte Seite el. Anschluss- leitung, Anschlusskabel Modbus) (Linke Seite Sensorkabel, Stromversorgung für Zubehör).
Update über KWL-BE Touch: 1. Laden Sie unter www�heliosventilatoren�de im Bereich Service unter Software die neueste easyControls 3.0 Firmware herunter. 2. Speichern Sie diese Datei auf einer leeren Micro SD Karte und schalten Sie ihr KWL- Gerät aus.
Internet verbunden sein� 5�2 Elektrische Nachheizung KWL-Anlage mit elektrischer Nachheizung, extern (SS-1424) 5�2�1 Zur Installation erforderliche Bauteile – Lüftungsgerät mit easyControls 3.0 Steuerung – EHR 1,2/125 oder EHR 2,4/160 – 1 x KWL-EM eC – KWL-LTK eC 5�2�2 Einstellung über Weboberfläche 1.
Operating Instructions Extension module KWL-EM eC for easyControls CHAPTER 1 1�1 Important information GENERAL In order to ensure complete and effective operation and for your own safety, all of the INFORMATION following instructions should be read carefully and observed. This document should be regarded as part of the product and as such should be kept accessible and durable to ensure the safe operation of the fan.
All versions of this documentation must be observed, otherwise the warranty shall cea- se to apply. The same applies to liability claims against Helios. The use of accessory parts, which are not recommended or offered by Helios, is not permitted. Any possible damages are not covered by the warranty.
Orient the KWL-EM eC with Helios lettering downwards� NOTE ⓘ The latest version of the operating instructions can be downloaded from Helios- Select at www�HeliosSelect�de at the corresponding article� CHAPTER 4 4�1 Electric connection...
Operating Instructions Extension module KWL-EM eC for easyControls The safety instructions in section 1�2, 1�3 must be observed! WARNING 1. Open the casing cover. 2. Slide the cable glands on the connection cable (right side el. connection cable, Mod- bus connection cable) (left side sensor cable, power supply for accessories). 3.
The ventilation unit will now directly download and install the latest software version in the background. Update via KWL-BE Touch: 1. Download the latest easyControls 3.0 firmware at www�heliosventilatoren�de in the Service area under Software. 2. Save this file to an empty Micro SD card and turn off the ventilation unit.
Controls cloud service� 5�2 Electrical post-heating KWL system with electrical post-heating, external (SS-1424) 5�2�1 Components required for installation – Ventilation unit with easyControls 3.0 control system – EHR 1.2/125 or EHR 2.4/160 – 1 x KWL-EM eC – KWL-LTK eC 5�2�2 Setup via web interface...
5�3 Warm water post-heating WW post-heating with WHSH HE 24V (0-10V) 5�3�1 Components required for installation – Ventilation unit with easyControls 3.0 control system – WHR 125 or WHR 160 – WHSH HE 24V (0-10V) – 1 x KWL-EM eC –...
Protègent aussi de tout contact avec des surfaces brûlantes. Pour le fonctionnement, le raccordement et l’utilisation, contacter Helios en cas de doutes. Des informations supplémentaires sont consultables dans les normes et textes de loi.
1�8 Domaines d’utilisation Le module d‘extension KWL-EM eC peut être raccordé via Modbus à toutes les cen- trales compactes KWL de la gamme Helios équipée d‘une régulation easyControls 3.0. ATTENTION Une utilisation non conforme est interdite ! 1�9 Description des fonctions...
Fixer le module KWL-EM eC au mur à l‘aide du matériel de fixation approprié par les trous de vis prévus dans les coins du boîtier. Le module KWL-EM eC doit être positionné avec le sigle Helios placé en bas� REMARQUE ⓘ...
Notice de montage et d‘utilisation Module d‘extension KWL-EM eC pour easyControls Veiller à appliquer les consignes de sécurité du chapitre 1�2, 1�3 ! AVERTISSEMENT 1. Ouvrir le couvercle du boîtier. 2. Visser les presse-étoupes sur le câble de raccordement (câble de raccordement électrique côté...
Mise à jour via la KWL-BE Touch: 1. Télécharger la dernière version du micrologiciel easyControls 3.0 sur le site www�heliosventilatoren�de dans l‘onglet service, rubrique Logiciels. 2. Enregistrer ce fichier sur une carte Micro SD vierge et désactivez l’appareil KWL.
à l‘Internet� 5�2 Post chauffage électrique Système KWL avec post chauffage électrique, externe (Schéma-1424) 5�2�1 Composants nécessaires à l‘installation – Centrale avec système de régulation easyControls 3.0 – EHR 1,2/125 ou EHR 2,4/160 – 1 x KWL-EM eC – KWL-LTK eC 5�2�2 Réglage via l‘interface web...
5�3 Post chauffage à eau chaude Post chauffage à eau chaude avec WHSH HE 24V (0-10V) 5�3�1 Composants nécessaires à l‘installation – Centrale avec système de régulation easyControls 3.0 – WHR 125 ou WHR 160 – WHSH HE 24V (0-10V) –...
Notice de montage et d‘utilisation Module d‘extension KWL-EM eC pour easyControls 6�1 Schéma de raccordement CHAPITRE 6 VUE D‘ENSEMBLE Longueur du câble Modbus : 100 m maximum KWL-KNX Il faut utiliser des paires de fils torsadés. DES PLANS DE KWL-EM eC Connect Numéro de pos te: RACCORDEMENT...
Need help?
Do you have a question about the easyControls 3.0 and is the answer not in the manual?
Questions and answers