Canon S830D Quick Start Manual page 56

Error number: 103
Cause: Position of paper thickness lever is incorrect and ink level is low.
Corrective action:
Prepare a replacement ink tank. Replace the ink tank (see page 56), and set the paper thickness
lever to the correct position to start printing. Press the Print button to restart printing under the
current conditions.
Error number: 201
Cause: Ink has run out.
Corrective action:
Press the Cancel button to stop printing, and then replace the ink tank (see page 56). Press the
Reset button on the printer to start printing without any ink.
Error number: 202
Cause: Waste ink tank is full.
Corrective action:
Press the Reset button on the printer to restart printing. Immediately contact the store where you
bought the printer or a repair center and request replacement of the waste ink tank.
Error number: 301, 302
Cause: No paper, paper cannot be fed, or paper jam.
Corrective action:
Load paper correctly, and press the Reset button on the printer to start printing. If a sheet is
jammed, remove the jammed sheet (see page 2), load paper correctly, and then press the Reset
button on the printer.
Error number: 401
Cause: Front cover is open.
Corrective action:
Close the front cover to start printing.
Error number: 402
Cause: Print head is not attached.
Corrective action:
Attach the print head (see page 6). If the print head is attached, remove the print head, ensure that
the contact sections are clean, and then reattach the print head.
Error number: 611, 612
Cause: Time Out is activated during communication with the digital camera.
A message that this printer does not support is sent from the digital camera.
Corrective action:
Remove the connected cable to reset the error. Reconnect the cable to the digital camera, and then
start printing. For instructions on printing from a digital camera, see the user's guide that comes with
the digital camera.
Error number: 802, 803, 809
Cause: Error occurred in printer.
Corrective action:
Press the Cancel button to stop printing, turn off the printer, wait awhile, and then turn on the power
again. If the condition does not improve, contact the store where you bought the printer or a nearby
repair center.
54