Table of Contents
Advertisement
en Installation instructions
Replace all of the bypass nozzles in the appliance.
1.
You can find additional information about this in the
section entitled "Removing the control panel"
→ Page 34.
2.
Then carry out the steps in the section entitled "Re-
placing the bypass nozzles" → Page 35.
Then carry out the steps described in the section
3.
entitled "Installing the control panel" → Page 35.
Removing the control panel
If the appliance has an upper cover, remove this.
1.
To do this, open the hob cover, grip the sides
‒
with both hands and pull it upwards. Ensure that
you do not lose the hinges.
Remove the pan support grids or the pan support
2.
racks and the burner parts.
If burner connection screws are present on the hob,
3.
remove all of these.
34
Remove the two screws (T20) at the front right and
4.
left of the hob panel. Do not remove the plastic
parts that are located below these.
5.
Note: To ensure that no scratches are formed on
the matte glass plate, do not allow the underside of
the hob to come into contact with objects.
Hold the front section of the hob and tilt it upwards
at a maximum angle of 30°. Secure the hob with
the profile bar by placing it vertically on the front
burner mount.
Remove the plastic covers from the front profiles on
6.
the right and left. Ensure that the covers are not
damaged or scratched. Unscrew the screws (T20)
below these.
Advertisement
Table of Contents
