Canon BJC-4300 Series User Manual page 52

Set the paper
thickness lever
for banner
paper.
2
Cut the banner at
a crease
according to the
length you need.
3
Insert the banner
paper.
Open the front cover. Use both hands to open the front cover.
Set the paper thickness lever to the right.
Close the front cover.
The maximum length you can use is six sheets (66 inches or 1676mm).
Always leave an extra sheet at the end of the banner- just in case the type runs
over.
Align the first sheet of the paper with the right edge of the sheet feeder and slide
it into the printer until it stops.
Then adjust the paper guide to the edge of the paper.
Do not allow the paper to hang over the edge of the desk or work table.
Do not extend the paper support when loading banner paper.
4300 Chapter 3 Page 25