Greenheck SE-1 Manual page 15

Mounting Options
Flush Interior
Flush Interior: The fan and housing will be outside the
building and the end of the housing will be flush with the
interior wall.
Flush Exterior: The fan and housing will be inside the
building and the end of the housing will be flush with the
exterior wall.
Motor and Drive Accessed from -
Inside of Building
- Damper Outside
Exhaust - Flush Interior
MOTOR
ACCESS
BUILDING
INTERIOR
Supply - Flush Interior
MOTOR
ACCESS
BUILDING
INTERIOR
Wall housing or wall collar should be tipped
slightly to the outside for water drainage.
Motor Access: The motor and drives can be placed
on either side of the propeller for access to grease
bearings, check or change belts and inspect the motor/
wiring connections. Failure to assess the best access
point can place maintenance personnel in extreme
danger if they must reach through the propeller.
Outside of Building
Exhaust - Flush Interior
MOTOR ACCESS
BUILDING EXTERIOR
Supply - Flush Interior
MOTOR ACCESS
BUILDING EXTERIOR
- Damper Inside
15