• Do not use the device in potentially explosive rooms or areas and do not install it there. • Do not use the device in aggressive atmosphere. fan heater TFC 21 E...
Page 3
The device was designed for private usage and is not suited for commercial use. The device is particularly well • Make sure that the air inlet and outlet are not obstructed. suited for additional heating. The device is only intended for floor installation. fan heater TFC 21 E...
Page 4
Improper installation entails a risk of fire. mounted. Do not place the device on combustible ground. Do not place the device on high-pile carpets. Warning In order to avoid overheating and fire hazards, the device must not be covered! fan heater TFC 21 E...
• If required, use a cover to protect the device from invasive dust. • Place no further devices or objects on top of the device to prevent it from being damaged. • Remove batteries from the remote control. fan heater TFC 21 E...
3. Attach the device on the foot (4) from above so that the When positioning the device, observe the minimum distance clips (9) on the device are exactly aligned with the from walls or other objects as described in the chapter recesses at the foot (4). Technical annex. fan heater TFC 21 E...
Is illuminated when automatic switch-on or switch-off has been activated Heating level 1 LED Is illuminated when heating level 1 (1300 W) is activated Oscillation button Switching oscillation on or off ECO mode LED Is illuminated when the ECO mode is activated fan heater TFC 21 E...
Page 9
ð The device stops heating automatically if the room Info temperature is above 25 °C. After approx. 1 minute without any input, the display is Note dimmed automatically. The temperature settings cannot be changed in this operating mode. fan heater TFC 21 E...
Page 10
The activated function at switch-off will be started again automatically when the device is switched on the next time. The Timer function is an exception to this. Note All settings can be adjusted via the remote control. fan heater TFC 21 E...
3. Allow the device to cool down sufficiently. • The overheating protection may have been tripped. Have a 4. Hold onto the mains plug while pulling the power cable out specialist electrical company or Trotec check the electrics of the mains socket. and replace the overheating protection.
Only then switch the device back on. The device still does not operate correctly after these checks: Please contact the customer service. If necessary, bring the device to an authorised specialist electrical company or to Trotec for repair. fan heater TFC 21 E...
Page 13
1. Remove the air filter (6) from the device. 2. Clean the air filter (6) using a slightly damp, soft, lint-free cloth. If the filter is heavily contaminated, clean it with warm water mixed with a neutral cleaning agent. fan heater TFC 21 E...
178 x 230 x 660 mm (depth x width x height) Minimum distance to walls and other objects A: top: 100 cm B: rear: 100 cm C: side: 100 cm D: front: 100 cm Weight 3 kg Remote control batteries CR 2032 fan heater TFC 21 E...
Page 15
Room temperature control, with open window detection With distance control option With adaptive start control With working time limitation With black bulb sensor Contact details Trotec GmbH Grebbener Straße 7 D-52525 Heinsberg NA = not applicable fan heater TFC 21 E...
According to Waste Electrical and Electronic Equipment Regulations 2013 (SI 2013/3113) and the Waste Batteries and Accumulators Regulations 2009 (SI 2009/890), devices that are no longer usable must be collected separately and disposed of in an environmentally friendly manner. fan heater TFC 21 E...