• Do not use the device in potentially explosive rooms or areas and do not install it there. • Do not use the device in aggressive atmosphere. fan heater TFC 25 E...
Page 3
The device was designed for private usage and is not suited for commercial use. The device is particularly well • Make sure that the air inlet and outlet are not obstructed. suited for additional heating. The device is only intended for floor installation. fan heater TFC 25 E...
Page 4
Before any work on the device, remove the mains plug from the mains socket! Do not touch the mains plug with wet or damp hands. Hold onto the mains plug while pulling the power cable out of the mains socket. fan heater TFC 25 E...
• If required, use a cover to protect the device from invasive dust. • Place no further devices or objects on top of the device to prevent it from being damaged. • Remove battery from the remote control • Remove batteries from the remote control. fan heater TFC 25 E...
2. Attach the foot (4) to the device from below, so that the When positioning the device, observe the minimum distance clips (9) of the device engage into the recesses of the foot. from walls or other objects as described in the chapter Technical annex. fan heater TFC 25 E...
Is illuminated when heating level 1 (1800 W) is activated Timer LED Is illuminated when automatic switch-off has been activated Cold air operation LED Is illuminated when Cold air operation is active Oscillation button Switching Oscillation on or off fan heater TFC 25 E...
Page 9
ð An acoustic signal is emitted. ð The target temperature set most recently will be indicated on the display. ð At initial start-up, the target temperature is preset to 25 °C. ð The device is switched on. fan heater TFC 25 E...
Page 10
• If you select the set number of hours of 0, the timer will be off. Note The device must not be left unattended in a freely accessible room with an activated timer. fan heater TFC 25 E...
• The overheating protection may have been tripped. Have a specialist electrical company or Trotec check the electrics and replace the overheating protection. • Wait for 10 minutes before restarting the device. If the device is not starting, have the electrics checked by a specialist company or by Trotec.
3. Check the inside of the device for dirt. 4. If you see a thick layer of dust, have the inside of the device cleaned by a specialist electrical company or by Trotec. 5. Put the air filter back in. fan heater TFC 25 E...
260 x 260 x 800 mm (depth x width x height) Minimum distance to walls and other objects A: top: 100 cm B: rear: 100 cm C: side: 100 cm D: front: 100 cm Weight 3.5 kg Remote control batteries Type CR2032 fan heater TFC 25 E...
Page 14
Room temperature control, with open window detection With distance control option With adaptive start control With working time limitation With black bulb sensor Contact details Trotec GmbH Grebbener Straße 7 D-52525 Heinsberg NA = not applicable fan heater TFC 25 E...
According to Waste Electrical and Electronic Equipment Regulations 2013 (SI 2013/3113) and the Waste Batteries and Accumulators Regulations 2009 (SI 2009/890), devices that are no longer usable must be collected separately and disposed of in an environmentally friendly manner. fan heater TFC 25 E...