Commissioning, Maintenance/Repair, Troubleshooting, Conversion And Service; Ergonomics, Workplace Safety; Labels On The Machine; Warning And Information Signs On The Machine - IML FastWheel Original Operating Instructions

Safety
3.7 Commissioning, maintenance/repair, troubleshooting, conversion and
service
The following must be ensured during and until the final completion of the work:
•
Switch off the machine electrically, allow it to come to a complete standstill and se-
cure it against being switched on again.
•
Inform the operating personnel about the work.
•
Have electrical work carried out by qualified electricians only. Observe the five safety
rules of electrical engineering.
•
Use state-of-the-art workshop equipment including the prescribed special tools or
mounting devices.
•
Restore the original setting ranges after repairs, refitting or modifications.
3.8

Ergonomics, workplace safety

•
Ensure sufficiently dimensioned lighting in the surrounding area.
•
Ensure good visibility of the machining process.
3.9

Labels on the machine

3.9.1

Warning and information signs on the machine

Labels are attached to the machine to provide additional information and warn of hazards
when handling the machine. The labels must be kept in legible condition throughout the
machine's service life and replaced immediately if damaged.
No. Warning / information sign
1
3.9.2

Type plate

The type plate contains the following information:
•
Name and full address of the manufacturer
•
Designation of the machine
•
CE mark
•
Model
•
Machine no.
•
Year of manufacture
•
Machine data
8
Implications for the users
Follow the instructions for use!
•
Read these operating instructions before switch-
ing on the machine.
FastWheel_V1.1_211123_EN