Philips GC9640/65 User Manual page 7

Problem Possible cause
The appliance is not hot enough
to produce steam.
You did not press the steam trigger.
The water tank is not placed in the
appliance properly.
The appliance is not switched on.
The appliance has The auto-off function is activated
switched off. The automatically when the appliance
light in the on/off has not been used for more than 10
button flashes. minutes.
The appliance Water is pumped into the boiler
produces a inside the appliance. This is
pumping sound. normal.
Solution
Wait until the 'iron ready' light on the iron lights
up continuously.
Press the steam trigger and keep it pressed
while you iron.
Slide the water tank back into the appliance
firmly ('click').
Insert the plug in the wall socket and press the
on/off button to switch on the appliance.
Press the power on/off button to switch on the
appliance again.
If the pumping sound continues nonstop, switch
off the appliance and remove the plug from the
wall socket. Contact an authorised Philips
service centre.
ENGLISH 9