Advertisement
Available languages
Available languages
1
Hold the iron in vertical position, press the steam trigger and touch the garment slightly with the
soleplate (Fig. 7).
Energy saving
ECO mode
-
By using the ECO mode (reduced amount of steam), you can save energy without compromising on the
ironing result. The green light is on (Fig. 8).
-
You can deactivate the ECO mode by pressing the ECO button. The green light goes off.
Safety auto-off mode
-
To save energy, the appliance switches off automatically when it has not been used for 10 minutes. The
auto-off light in the on/off button starts to flash (Fig. 9).
-
To activate the appliance again, press the on/off button. The appliance then starts to heat up again.
Note: The appliance is not switched off completely when it is in safety auto-off mode. To switch off the
appliance, press the on/off button.
Turbo steam
For faster ironing and a higher amount of steam, you can use Turbo steam.
1
Press and hold the on/off button for 2 seconds until the light turns white. (Fig. 10)
2
To deactivate Turbo steam, press and hold the on/off button again for 2 seconds until the white light turns
blue
Ironing tips
Minimising wrinkles while drying
Start wrinkle removal early in the drying process by spreading out your laundry properly after washing and by
putting garments on hangers to make them dry naturally with fewer wrinkles.
Best practice shirt ironing
Start with the time-consuming parts like collar, cuff links and sleeves. Next, iron the bigger parts like front and back to
prevent wrinkling the bigger parts when you are busy ironing the time-consuming parts.
Collar: When you iron a collar, start on its underside and work from the outside (the pointy end) inwards. Turn
over and repeat. Fold down the collar and press the edge for a more crisp finish.
Buttons: Iron on the reverse side of the buttons for more effective and faster ironing.
IMPORTANT - DESCALING
It is very important to perform the descaling procedure as soon as the EASY DE-CALC light starts to flash and the
appliance beeps continuously.
The EASY DE-CALC light flashes and the appliance beeps continuously after about a month or 10 ironing
sessions to indicate that the appliance needs to be descaled. Perform the following descaling procedure before
you continue ironing.
To avoid the risk of burns, unplug the appliance and let it cool down for at least two hours before you perform
the descaling procedure.
1
Remove the plug from the wall socket (Fig. 11).
2
Place the appliance on the edge of the tabletop.
3
Hold a cup (with a capacity of at least 350ml) under the EASY DE-CALC knob and turn the knob
anticlockwise (Fig. 12).
4
Remove the EASY DE-CALC knob and let the water with scale particles flow into the cup (Fig. 2).
ENGLISH
7
Advertisement
