Setting The Audio Mix - Canon ZR Instruction Manual

Setting the Audio Mix

When you play back a tape that was recorded in 12 bit mode, you can set the audio
output: stereo 1 (the original sound), stereo 2 (any new sound, dubbed to the tape
after recording), or a mixture of the two.
• Audio from the 16 bit mode only contains stereo 1 sound and so you cannot/do
not need to select the audio mix. The same is true for the 12 bit stereo 1 mode,
unless new sound has been added post-recording.
1. Set the camera to VCR mode.
A.MONITOR••• MIX/VARI.
(see p. 28)
2. Choose the output.
• Open the VCR menu and point the arrow at A.MONITOR.
• Select the output and return to the main menu:
- STEREO1 for just stereo 1.
- STEREO2 for just stereo 2.
- MIX/FIXED when you want an equal mix of stereo 1 and 2.
- MIX/VARI. when you wish to mix the balance between stereo 1 and 2.
3. Mix the balance.
• If you chose MIX/VARI. (above) you can now select the MIX BALANCE
option from the menu and adjust the mix between stereo 1 and 2. A bar
showing the mix appears on the screen as a guide.
Note:
• When you have chosen the output, FIXED or VARIABLE is shown in the top
left of the display for a few seconds. If you turn the power off the output (and
display) is set to "STEREO1".
OFF VCR POWER
MENU
E
63