Canon VIXIA HF M301 Instruction Manual page 175

e Some scenes were recorded using another device and cannot be copied.
- Scenes that were not recorded with this camcorder cannot be copied to the memory card.
Task in progress. Do not disconnect the power source.
- The camcorder is updating the memory. Wait until the operation ends and do not disconnect
the compact power adapter or remove the battery pack.
The camcorder is set to photo mode
- You pressed g while recording photos (
or mode to record movies.
The lens cover is not fully open. Turn the camcorder off, then on again.
- The lens cover did not open fully. Turn the camcorder off, then on again. If this does not solve
the problem, consult a Canon Service Center.
This memory card contains scenes. Delete all scenes to use relay recording.
- Save your movies (0 129) if necessary, and delete all the movies from the memory card
(0 57).
This photo cannot be displayed
- You may not be able to display photos taken with other devices or image files created or
edited on a computer.
This B photo could not be deleted
- Protected photos (B) cannot be deleted. Remove the protection (0 116).
This scene was recorded using another device and cannot be added to the playlist.
- Scenes that were not recorded with this camcorder cannot be added to the playlist.
e This scene was recorded using another device and cannot be copied.
- Scenes that were not recorded with this camcorder cannot be copied to the memory card.
To record video on this memory card, it is recommended to use only the XP+/SP/LP recording
modes
- Movies may not be recorded correctly on this memory card if the recording mode is set to
MXP or FXP mode (0 60).
To use this function change the camcorder's mode from 5 to y
- You pressed a button that cannot be used in
the camcorder to flexible recording mode.
Too many photos. Disconnect the USB cable.
- Disconnect the USB cable. Try using a memory card reader or decrease the number of photos
on the memory card to fewer than 2,500 photos (printers, Windows computers), or 1,000
photos (Macintosh computers).
- If a dialog box appeared on the computer screen, close it. Disconnect the USB cable, and
restore the connection after a short while.
mode). Set the camcorder to
mode. Set the mode switch to y to set
Additional Information

175