Advertisement
Operating Instructions
Ensure the appliance is placed on a level, stable support surface clear of
surrounding obstacles. Locate the main on/off switch on the side of the body
and check this is in the off position. Plug the supply cord plug into a socket
outlet and switch on. Switch the main on/off switch to the on position and an
audible "beep-beep' noise will be heard. The appliance is now in the
standby mode.
C)
1.
ON/Standby.
In the standby mode, control buttons will not be active. Once the standby
button is pressed, the appliance will default to 23℃ Eco mode . Press this
key again to enter the standby state.
2. OFF .
Press the standby button, then press the on/off control switch below the control
panel.
3.
Power mode.
Press the power mode button, consecutive presses will cycle between Eco
mode, High Power, Medium Power, and Low Power, step through until the
desired setting is selected.
Eco Mode.
4.
When Eco mode is selected (as above, use power mode button to step through
until this is set, the display panel will show "Eco". Under this mode, the heating
power will adjust automatically when the room temperature is approaching the
set temperature. Example: The heater is set to 25℃. When the room
temperature is less than 22℃, the heater will operate under High power. When
the room temperature rises to 23℃, the heater will switch to operate at Medium
power. When the room temperature rises to 24℃, the heater will switch to
operate under low ower. When the room temperature reaches the set
temperature 25℃, the heater will switch off automatically. When the room
temperature becomes less than the set temperature, the heater will switch on
again under Eco mode.
AFTER.SALES SUPPORT
'8' �
0800 422 274
Kensington.
9
Advertisement
